Greetings! I hope you are enjoying a wonderful day. I have a little Stampin’ Up! Punch Art Gnome to brighten your day if you need it! This card is for The Paper Players Challenge PP 568 CAS(Clean and Simple) Gnomes or Fairies.
My Gnome Punch Art Card
I did not have any stamps with gnomes or fairies. I decided to try to make a gnome with Punch Art. Punch Art used to be the art of making images using the Stampin’ Up! punches. However, right now there are not many punches in basic shapes like circles, squares and triangles. But there are many shapes in the Stampin’ Up! Dies that can be used!
The face and the boots are made from the Ice Cream Cone Builder Punch. The black lines are where I cut the punch. The little pompom for the gnome hat is from the Pierced Blooms Dies. The remaining pieces are different sizes of triangles from the Stitched Triangle Dies. The face is Blushing Bride Card Stock (CS). For the hat I used the Tidings of Christmas 6 x 6 Designer Series Paper (DSP). The boots are made with Early Espresso CS and the body is made with Soft Succulent CS. The beard and the pompom are in Basic White CS.
First place the triangle for the body on the card front to be able to position the boots. After adhering the boots, use Stampin’ Dimensionals to adhere the body. Trim off the very tip of the triangle for the body.
Slide the white beard triangle under the “nose”. Then adhere the hat. Position the Stampin’ Dimensionals as shown.
Adhere the face with the beard and hat over the body. Stamp your greeting. I used the greeting from the Joyful Life stamp. The greeting is stamped in Soft Succulent ink.
Adhere the card front to a 5 1/4 x 4 inch piece of the Christmas Tidings DSP. Finish the card by adhering this piece to the front of an 11 x 4 1/4 inch Basic White CS card base.
Voila! A cute gnome is created for a whimsical holiday card! Stop by The Paper Players Challenge PP568 to see more cards made in the “Clean and Simple” style with gnomes or fairies.
I hope this card has brightened your day a little if you needed it. Stop by tomorrow for a 3D Thanksgiving shaker card made with the Stampin’ Up! Cloche Shaker Dome!
Remember that if you wish to subscribe to my newsletter, you can do so by scrolling down the side bar until you get to the “Subscribe to My Newsletter” form. I sent my very first Theresa’s Treasures Paper Crafts Newsletter out this past Monday. Constructive feedback on how to make my newsletter better for you is welcome.
Supplies to make this card
Click on any photo to go to my Online Store.
I hope you have a great day!
6 thoughts on “Stampin’ Up!® Punch Art Gnome Using the Ice Cream Cone Builder Punch and Stitched Triangle Dies”
Bravo Theresa – your punch art gnome is so creative and I love your die/punch combo! I never know what to use my triangles for, so this is a revelation! Thanks for joining us over at The Paper Players this week!
Thank you. I hope you give it a try. I had a lot of fun with this card!
Love it!!! Super cute! Great punch art card!!😊
Thank you very much! This was a fun one!
So dang cute! Thanks
Thanks so much!